Recommendations; Safety; Security Of Your Terminal; Telephone Call - Ingenico IWL2 series User Manual

Wireless
Hide thumbs Also See for IWL2 series:
Table of Contents

Advertisement

6.

Recommendations

6.1.

Safety

Powering down the iWL2XX base :
Disconnect the iWL2XX power supply block adapter from the electrical mains
network.
Lithium cell (Backup battery)
The iWL2XX is fitted with an internal lithiu m cell which can only be accessed by a
qualified technician.
Battery
iWL2XX is fitted with battery specially designed for this terminal.
Only use the appropriate chargers and batteries listed in the Ingenico's catalogu e.
Do not short-circuit the battery.
Do not attempt to remove the battery housing as its components cannot be
modified.
Do not disassemble
Batteries in "end oflife" mu st be disposed of at the appropriates sites.
The lifespan depends on:
Features
Cycle number of charge and discharge
Use temperature
Warning
There is a risk of explosion if the battery is incorrectly replaced.
Never place the battery next to a warmth source or in fire.
Electrical power outlet
The electrical outlet must meet the following criteria :
Must be installed near the equipment and easily accessible;
Must meet standards and regulations in the country where used;
The protection of the installation must be set to 20 A.
Telephone network
The phone jack must comply with standards and regulations in the country where
used.
iWL2xx Wireless Series
21/32
900003061 R11 000 05/1122
Copyright © 2011 Ingenico
All rights reserved
SAM1/SAM2/SIM readers compartment
The trapdoor for battery, SAM1/SAM2/SIM, readers located underneath the terminal,
must be in place during the normal operation of the terminal. See sections "Removal
of SAM1/SAM2/SIM , modules" as well as "Connecting the battery".
On airplanes
You r handset must be switched off by removing the battery pack. Remove the
battery from the terminal when on an airplane.
Non-compliance with these safety rules may result in legal action and/or a ban on
later access to cellular network services.
Explosion areas
Some regulations restrict the use of radio equipment in chemical plants, fuel depots
and any site where blasting is carried out. You are urged to comply with these
regulations. The terminal shall be protected by a specially fitted and certified cover
enabling use in proximity to a fuel pump.
Electronic health appliances
You r handset is a radio transmitter which may interfere with health appliances, such
as hearing aids, pacemaker, hospital equipment, etc.
Your doctor or the equipment manufacturer will be able to provide you with
appropriate advice.
6.2.

Security of your terminal

Upon receipt of your terminal you should check for signs of tampering of the equipment. It
is strongly advised that these checks are performed regularly after receipt. You should
check, for example: that the keypad is firmly in place; that there is no evidence of unusual
wires that have been connected to any ports on your terminal or associated equipment, the
chip card reader, or any other part of your terminal. Such checks would provide warning of
any unauthorised modifications to your terminal, and other suspicious behaviour of
individuals that have access to your terminal. Your terminal detects any "tampered state".
In this state the terminal will repeatedly flash the message" Alert Irruption!" and further
use of the terminal will not be possible. If you observe the "Alert Irruption!" message, you
should contact the terminal helpdesk immediately.
You are strongly advised to ensure that privileg ed access to your terminal is only granted to
staff that have been independently verified as being tru stworthy.
CAU TION
NEVER ask the customer to divulge their PIN Code. Customers should be advised to ensure
that they are not being overlooked when entering their PIN Code.
The terminal must never be put in or left at a location where it could be stolen or replaced
with another device.
6.3.

Telephone call

You have an urgent call to make while the iWL2XX is occupying the line.
In order to get a dial tone in short time:
Place the handset in the hang up position pressing the red key (=cancel)
or
disconnet the base power supply from the mains network
or
disconnet the iWL2XX telephone connector from the telephone call socket, and
place the telephone connector into the telephone wall socket.
You hear a dial tone within 6 seconds.
iWL2xx Wireless Series
22/32
900003061 R11 000 05/1122
Copyright © 2011 Ingenico
All rights reserved

Advertisement

Table of Contents
loading

Table of Contents