Intermec CN4 User Manual page 75

CN4 Series Mobile Computer User's Manual
e Press Enter.
8 Save your settings and exit Intermec Settings.
To enable WPA-PSK with Microsoft security
1 Make sure the communications and radio parameters on your
CN4 are configured.
2 Start Intermec Settings.
3 Choose Communications > 802.11 Radio > Microsoft Security.
4 For Infrastructure Mode, choose Infrastructure.
5 For Network Authentication, choose WPA-PSK. Data
Encryption automatically defaults to TKIP.
6 For Pre-Shared Key, enter the pre-shared key or the passphrase.
The pre-shared key must be a value of 32 hex pairs preceded by 0x
for a total of 66 characters. The value must match the key value on
the authenticator. The passphrase must be from 8 to 63
characters. After you enter a passphrase, the CN4 internally
converts it to a pre-shared key.
This value must match the passphrase on the authenticator.
7 Tap OK. Your settings are saved.
Configuring 802.1x Security with Microsoft Security
1 Make sure the communications and radio parameters on your
CN4 are configured.
2 Start Intermec Settings.
3 Choose Communications > 802.11 Radio > Microsoft Security.
4 For Infrastructure Mode, choose Infrastructure.
5 For Network Authentication, choose Open.
6 For Data Encryption, choose WEP.
7 For 802.1X Authentication, choose TLS or PEAP.
8 If you choose TLS:
a Select Properties and tap the Run App button. The Auth.
Settings box appears.
b Tap the Select button.
Chapter 2 — Connecting and Configuring the CN4
55