Restore "Factory Default" Program Settings - Rain Bird ESP-SMT Installation & Operation Manual

Restore "Factory Default"
Program Settings
E The RESTORE SETTINGS FROM
screen will appear and Contractor
Defaults will be blinking. Press the
UP or DOWN button(s) until the
Factory Defaults begins to blink;
then press the SELECT button.
RESTORE CURRENT SETTINGS FROM
F
Factory Defaults will appear. Press
the RESTORE button.
G A WARNING screen will appear. If
you want to continue to restore the
original factory settings. Press the
CONTINUE button.
H The RESTORING TO Factory Defaults
screen will appear with a message
that reads: Please Wait While Unit
Reconfigures.
I While the ESP-SMT is restoring
the Factory Default settings, the
screen as shown will appear until all
information has been programmed
into the ESP-SMT controller.
!
NOTE: If you elect to restore
Factory Defaults, all previously
programmed information will be
erased and replaced with Factory
default values. Information saved
in Contractor Defaults is not
erased.
RESTORE SETTINGS FROM
Contractor Defaults
E
Factory Defaults
RESTORE CURRENT
SETTINGS FROM:
F
Factory Defaults
QUIT
WARNING
Restoring Factory
G Defaults Will Delete
ALL Current Settings.
Contractor Defaults
Will Be Retained.
QUIT
H
SELECT
I
RESTORE
RESTORE
ESP-SMT Smart Modular Control System
RESTORING TO
Factory
Defaults
Please Wait While
Unit Reconfigures
Rain Bird
ESP-SMT
Smart Modular
Controller
48