Rain Bird ESP-SMT Installation & Operation Manual page 88

This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation.
If the equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by the
following measures:
03/11
Changes or modifications not expressly approved by Rain Bird Sales,
Inc., could void the user's authority to operate the equipment.
This product was FCC certified under test conditions that included the
use of shielded I/O cables and connectors between system components.
To be in compliance with FCC regulations, the user must use shielded
cables and connectors and install them properly.
RAIN BIRD CORPORATION
6991 E. Southpoint Road
Tucson, AZ 85756
© 2011 Rain Bird Corporation
® Registered trademark of Rain Bird Corporation
www.rainbird.com
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for
help.
P/N: 637522-01
03/31/11