Rain Bird ESP-SMT Installation & Operation Manual page 68

Using a code-approved wire connector, connect the wires
as follows:
Strip the insulation from the incoming wires to expose
E
about 1/2" (1,3cm) of bare wire. Connect the black
supply wire ("hot") to the black transformer wire.
Connect the white supply wire ("neutral") to the white
F
transformer wire.
Connect the green supply wire ("ground") to the
G
green transformer wire.
!
NOTE: The ground wires MUST be connected to
provide electrical surge protection.
Verify that all connections are secure. Then close the
H
cover of the high-voltage compartment and secure it
with the screw.
!
NOTE: All electrical connections and wiring runs
must be made according to local building codes.
ESP-SMT Smart Modular Control System
63
E
CONNECT
120 VAC
G
F
H