Input Zone Information
This section shows you how to input information that is specific to each zone you plan
to irrigate. There are three methods to accomplish this task:
1) Zone Setup Wizard; 2) Advanced User Entry; 3) Copy Zone to Zone(s)
Method 1: Zone Setup Wizard
This method is recommended for new users of the ESP-SMT Controller.
Rotate the dial to INPUT ZONE INFORMATION position...
AUTO
OFF
MANUAL
WATERING
RESTORE
SETTINGS
SYSTEM
REVIEW
FINE-TUNE
WATERING
ESP-SMT Smart Modular Control System
19
A
SET DATE
Select Specific Zone Number
& TIME
B
CONFIGURE
CONTROLLER
INPUT ZONE
INFORMATION
Turn Zone to ENABLE status
C
SPECIAL
FEATURES
D
!
The INPUT ZONE INFORMATION
screen will appear with the Zone
Setup Wizard blinking; press the
SELECT button.
The SELECT ZONE screen will appear.
Press the - or + button(s) until the
desired Zone Number is displayed;
then press the NEXT button.
Zone OFF is displayed. Press the
ENABLE button to change zone
status.
Zone XX ENABLED is displayed;
press the NEXT button.
NOTE:
You can still input zone
information with the zone in the
OFF mode. This may be beneficial
INPUT ZONE INFORMATION
Zone Setup Wizard
A
Copy Zone to Zone
SELECT
SELECT ZONE
Zone
3
B
OFF
BACK
NEXT
SELECT ZONE
Zone 3
C
OFF
BACK
OFF
ENABLE
NEXT
SELECT ZONE
Zone 3
D
ENABLED
BACK
OFF ENABLE
NEXT