Rain Bird ESP-SMT Installation & Operation Manual page 63

The ESP-SMT Smart Modular controller has a single
F
keyhole slot at the rear top of the cabinet. At the
bottom of the cabinet are three circular mounting
holes. Mount the controller so that at least one of the
bottom holes lines up with a wall stud or other solid
surface.
Hold the mounting template at eye level against the
G
mounting surface. Use a pencil to mark the position
of the top keyhole slot and one or more of the bottom
holes.
H Drive an appropriate fastener for the type of wall into
the mark for the keyhole slot.
I Drill or tap a pilot hole on the mark for the lower
mounting hole(s). DO NOT drive a fastener into these
locations yet.
Hang the controller by the keyhole slot. Make sure the
J
fastener is well up in the narrow part of the keyhole.
Drive the appropriate fastener(s) into the lower
K
mounting hole(s). Verify that the cabinet is secure.
G
ESP-SMT SMART MODULAR CONTROLLER
MOUNTING TEMPLATE
Allow 11" clearance to the left side of the
template to allow the door to open fully.
#8 SCREW
J
ESP-SMT Smart Modular Control System
H
#8 SCREW
LEVEL LINE
#8 SCREW #8 SCREW
I
3X
K
3X
58