Rain Bird ESP-SMT Installation & Operation Manual page 76

Symptom
NOTE 1 on Display Screen.
NOTE 2 on Display Screen.
NOTE 3 on Display Screen.
NOTE 4 on Display Screen.
NOTE 5 on Display Screen.
NOTE 6 on Display Screen.
NOTE 7 on Display Screen.
NOTE 8 on Display Screen.
For technical assistance contact Rain Bird at 1-800-247-3782
ESP-SMT Smart Modular Control System
71
Possible Cause
All Zones are OFF.
All Watering Days are OFF.
Unusually High Temperature Reading.
Unusually High Rainfall Reading.
Watering Not Completed During Watering
Window.
Irrigation Suspended Due to Extreme
Cold.
Irrigation Suspended Due to Rain.
Unit is Re initializing, Please WAIT.
Correction
Rotate the dial to the INPUT ZONE INFORMATION position and change the status of each
desired zone to an ENABLED (Active) mode.
Rotate the dial to the CONFIGURE CONTROLLER position and change the Allowed Watering
Days.
Verify that the temperature sensor is not malfunctioning. Relocate the sensor in a different
location to measure more accurately the ambient temperature of the site.
Remove the Tipping Rain Bucket from the sensor housing. Clean with mild soap and water.
Verify that the tipping mechanism is functioning properly and reinsert the mechanism into
the sensor housing.
If this is an occasional occurrence, the controller will finish the required irrigation during the
next allowed watering day. If it is a regular occurrence, expand the Watering window while
in the CONFIGURE CONTROLLER dial position. Another solution is to use to FINE TUNE affected
zones.
If irrigation is desired at this temperature, rotate the dial to the SPECIAL FEATURES dial
position. Change the user set value to lower threshold temperature value.
If irrigation is desired at the current rainfall amount, rotate the dial to the SPECIAL FEATURES
dial position. Change the user set value to a higher rainfall threshold.
Unit has encountered a small problem. The controller will correct itself – no action is
necessary.