Table 8: Ucm6108/Ucm6116 Network SettingsBasic Settings - Grandstream Networks UCM6100 Series User Manual
Ip pbx
Hide thumbs
Also See for UCM6100 Series:
- User manual (418 pages) ,
- Manual manual (24 pages) ,
- Configuration (19 pages)
Table of Contents
Advertisement
DNS Server 1
Enter the DNS server 1 address for static IP settings. The default setting is 0.0.0.0.
DNS Server 2
Enter the DNS server 2 address for static IP settings.
User Name
Enter the user name to connect via PPPoE.
Password
Enter the password to connect via PPPoE.
Layer 2 QoS
Assign the VLAN tag of the layer 2 QoS packets for LAN port.
802.1Q/VLAN Tag
The default value is 0.
Layer 2 QoS 802.1p
Assign the priority value of the layer 2 QoS packets for LAN port. The default value
Priority Value
is 0.
IPv6 Address
LAN (when Method is set to "Switch")
IP Method
Select Auto or Static. The default setting is Auto
IP Address
Enter the IP address for static IP settings.
IP Prefixlen
Enter the Prefix length for static settings. Default is 64
DNS Server 1
Enter the DNS server 1 address for static settings.
DNS Server 2
Enter the DNS server 2 address for static settings.
LAN 1 / LAN 2 (when Method is set to "Dual")
Users will need assign the default interface to be LAN 1 (mapped to UCM6102
Default Interface
WAN port) or LAN 2 (mapped to UCM6102 LAN port) and then configure network
settings for LAN 1/LAN 2. The default interface is LAN 2.
IP Method
Select Auto or Static. The default setting is Auto
IP Address
Enter the IP address for static IP settings.
IP Prefixlen
Enter the Prefix length for static settings. Default is 64
DNS Server 1
Enter the DNS server 1 address for static settings.
DNS Server 2
Enter the DNS server 2 address for static settings.
MTU
Specifies the Maximum Transmission Unit. (By default, it is 1500)
IPv4 Address
Enter the preferred DNS server address. If Preferred DNS is used, UCM will try to
Preferred DNS Server
use it as Primary DNS server.
IP Method
Select DHCP, Static IP, or PPPoE. The default setting is DHCP.
IP Address
Enter the IP address for static IP settings.
Subnet Mask
Enter the subnet mask address for static IP settings.
Gateway IP
Enter the gateway IP address for static IP settings.
DNS Server 1
Enter the DNS server 1 address for static IP settings.
DNS Server 2
Enter the DNS server 2 address for static IP settings.
Table 8: UCM6108/UCM6116 Network SettingsBasic Settings
UCM6100 Series User Manual
P a g e
54
|
Advertisement
Table of Contents
Troubleshooting
