Firmware Version 1.0.12.19 - Grandstream Networks UCM6100 Series User Manual

•
Added ability to customize PAI Header. [PAI Header]
•
Added blacklist for outbound calls. [Outbound Blacklist]
•
Added support to upload/download MOH package from Web GUI. [MUSIC ON HOLD]
•
Added support to download custom prompts from Web GUI. [Download All Custom Prompt]
Added option to configure prompt timeout in Dial By Name. [DIAL BY NAME]
•
Added description field in ZeroConfig settings to configure Softkey/Line/MPK for GXP series phones.
[PROVISIONING]
•
Improved seamless transfer privilege control. [Seamless transfer privilege control]
•
Added RTP Keep-alive support. [RTP Keep-alive]
•
Added Email Send Log. [Email Send Log]
•
Added support for Mitel simulation/protocol interfaces for PMS module. [PMS]
•
Added support for up to 10 failover trunks. [Use Failover Trunk]

Firmware Version 1.0.12.19

•
Added support for binding a mobile phone number to extension [Mobile Phone Number]
•
Added support opus codec
•
Added support call-barging privilege settings based on extensions [Monitor privilege control]
•
Added support for Seamless Transfer [Enable Seamless Transfer]
•
Added support for Custom Call-Info for Auto Answer [Custom Call-info for Auto Answer]
•
Added support for DND Whitelist [DND Whitelist]
•
Add the Field Description on Softkey, Line keys and MPK from Zero Config
•
Added support to select interval for numbers on Batch add extension [Extension Interval]
•
Added support for Batch Add CallerID Number [CallerID Number]
•
Added support for Search Extensions Using CallerID Name
•
Added support to Enable/Disable Inbound and Outbound Route [Disable This Route] [Disable This
Route]
•
Added support for Outbound Route Time Condition [Time Condition]
•
Added support for IPv6 [IPv6 Address]
•
Added Support for MTU configurable [MTU]
•
Added support of CRM [CRM]
•
Added support for Custom Privilege in User Management [Custom Privilege]
•
Added Hotline support for FXS Extension [Hotline]
•
Added support for Separate Wakeup Service [WAKEUP SERVICE]
•
Added ability to provision phones from different network subnets using zero config [Subnet Whitelist]
•
One-key-dial is replaced by Speed Dial to support more than one digit [SPEED DIAL]
•
Added Append extension number in the end of DOD [Direct Outward Dialing (DOD)]
•
Support Japan CID NTT Detect
•
Added support for Ethernet Capture Auto Sync to SFTP Server [Enable SFTP Data Sync]
•
Added support for Ethernet Capture saved to External Storage Device [Storage to External Device]
•
Added support for Disable Extension Range on the Setup Wizard [Setup Wizard]
•
Added more support for Port Forwarding [Port Forwarding (UCM6102 only)]
•
Added support for USB/SD Card Files Cleanup [USB/SD Card Files Cleanup]
UCM6100 Series User Manual
P a g e 24
|