Configuring Re-Dhcp Portal Authentication With A Preauthentication Domain - HP MSR Series Configuration Manual

Hpe flexnetwork msr router series
Hide thumbs Also See for MSR Series:
Table of Contents

Advertisement

[Router] portal server newpt
[Router-portal-server-newpt] ip 192.168.0.111 key simple portal
[Router-portal-server-newpt] port 50100
[Router-portal-server-newpt] quit
# Configure a portal Web server.
[Router] portal web-server newpt
[Router-portal-websvr-newpt] url http://192.168.0.111:8080/portal
[Router-portal-websvr-newpt] quit
# Enable direct portal authentication on GigabitEthernet 2/0/2.
[Router] interface gigabitethernet 2/0/2
[Router–GigabitEthernet2/0/2] portal enable method direct
# Reference the portal Web server newpt on GigabitEthernet 2/0/2.
[Router–GigabitEthernet2/0/2] portal apply web-server newpt
# Configure the BAS-IP as 2.2.2.1 for portal packets sent from GigabitEthernet 2/0/2 to the
portal authentication server.
[Router–GigabitEthernet2/0/2] portal bas-ip 2.2.2.1
[Router–GigabitEthernet2/0/2] quit
Verifying the configuration
# Verify the portal configuration by executing the display portal interface command. (Details not
shown.)
# Display information about preauthentication portal users.
[Router] display portal user pre-auth interface gigabitethernet 2/0/2
MAC
0015-e9a6-7cfe
State: Online
VPN instance: --
Authorization information:
DHCP IP pool: N/A
Session group profile: N/A
ACL number: 3010
Inbound CAR: N/A
Outbound CAR: N/A
Configuring re-DHCP portal authentication with a
preauthentication domain
Network requirements
As shown in
obtains an IP address through the DHCP server. A portal server acts as both a portal authentication
server and a portal Web server. A RADIUS server acts as the authentication/accounting server.
Configure re-DHCP portal authentication. Before passing the authentication, the host is assigned a
private IP address and can access only the subnet 192.168.0.0/24. After passing the authentication,
the host gets a public IP address and can access other network resources.
IP
2.2.2.4
Figure
80, the host is directly connected to the router (the access device). The host
VLAN
Interface
--
GigabitEthernet2/0/2
196

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents