Conference [1..1] Presentation Onplacedonhold; Conference [1..1] Incomingmultisitecall Mode; Conference [1..1] Multipoint Mode - Cisco TelePresence MX200 Administrator's Manual

Cisco TelePresence MX200 and MX300
Contents

Conference [1..1] Presentation OnPlacedOnHold

Define whether or not to continue sharing a presentation after the remote site has put you on
hold.
Requires user role: ADMIN
Value space: <Stop/NoAction>
Stop: The video system stops the presentation sharing when the remote site puts you on
hold. The presentation will not continue when the call is resumed.
NoAction: The video system will not stop the presentation sharing when put on hold. The
presentation will not be shared while you are on hold, but it will continue automatically when
the call is resumed.
Conference 1 Presentation OnPlacedOnHold: NoAction
Example:

Conference [1..1] Multipoint Mode

Define how the video system handles multiparty video conferences.
If registered to a Cisco TelePresence Video Communication Server (VCS), the video system
can use the MultiWay network solution. MultiWay requires that the video network includes
a multipoint control unit (MCU). If registered to a Cisco Unified Communications Manager
(CUCM), the video system can use the CUCM conference bridge. Both MultiWay and the CUCM
conference bridge allows you to set up conferences with many participants.
Requires user role: ADMIN
Value space: <Auto/Off/MultiWay/CUCMMediaResourceGroupList>
Auto: The multipoint method available will be choosen automatically; if none are available the
Multipoint Mode will automatically be set to Off.
Off: Multiparty conferences are not allowed.
MultiWay: Multiparty conferences are set up using the MultiWay service. If MultiWay is
chosen when the MultiWay service is not available, the Multipoint Mode will automatically be
set to Off. This may occur when the NetworkServices MultiWay Address setting is empty or
not properly set.
CUCMMediaResourceGroupList: Multiparty conferences (ad hoc conferences) will be hosted
by the CUCM configured conference bridge. This setting is provisioned by CUCM in a CUCM
environment and should never be set manually by the user.
Conference 1 Multipoint Mode: Auto
Example:
D14850.12 MX200 and MX300 Administrator Guide TC7.3, JULY 2015.
Introduction Web interface System settings System settings

Conference [1..1] IncomingMultisiteCall Mode

Select whether or not to allow incoming calls when already in a call/conference.
Requires user role: ADMIN
Value space: <Allow/Deny>
Allow: You will be notified when someone calls you while you are already in a call. You can
accept the incoming call or not. The ongoing call may be put on hold while answering the
incoming call; or you may merge the calls (requires MultiSite or MultiWay support).
Deny: An incoming call will be rejected if you are already in a call. You will not be notified
about the incoming call. However, the call will appear as a missed call in the call history list.
Conference 1 IncomingMultisiteCall Mode: Allow
Example:
www.cisco.com — Copyright © 2011–2015 Cisco Systems, Inc. All rights reserved.
66
Administrator Guide
Setting passwords Appendices