Protocol Library Summary; Device Information; Patient Specific Parameters (Programming Screens) - Smiths Medical CADD-Solis Operator's Manual

To view the event log:
1. From the Reports
menu, press U or D
to choose Event Log
and press S.
While viewing the event log, you may quickly scroll
from the oldest to newest by selecting Show Oldest
or Show Newest.

Protocol Library Summary

The protocol library summary allows you to view
the protocol library currently installed in the pump.
This screen will tell you the name of the protocol
library, the revision, and the number of protocols in
the library.
To view the protocol library summary:
1. From the reports
menu, press U or D
to choose Protocol
Library Summary and
press S.

Device Information

The device information
screen allows you to view
the pump's information.
On this screen you will find
the pump's serial number,
software and hardware
version numbers, and the
last error code (if one exists).
NOTE: Review your facility's procedure for
handling error codes (see Understanding the Alarms
and Messages on page 35 for more information).
To view the device information:
1. From the reports
menu, press U or
D to choose Device
Information and press
S.
Programming and Operation
Patient Specific Parameters
(Programming Screens)
The patient specific parameters are found on
the home screen and can be edited within limits
that are set up by the CADD®-Solis system
administrator in the protocol. The CADD®-Solis
system administrator determines which parameters
can be viewed and/or edited on the home screen,
as well as the initial values of the parameters.
While determining the initial values, the CADD
Solis system
administrator will
also set up hard
and soft limits
which may allow
you to modify
the parameters as
necessary. The soft limits (displayed in green) will
be the range most commonly used for the protocol,
and the hard limits (displayed in amber) extend to
the highest and lowest amount that the CADD
Solis system administrator chooses to allow for
the protocol. If the doctor's orders do not match
the initial values, they should be edited to match.
Editing the parameters above or below the soft
limits will result in a
screen that requires
you to confirm the
soft limit override.
You will need the
keypad (or a higher
level) code or the pump key
to edit the patient specific parameters. The CADD
Solis system administrator determines if the pump
key can be used to unlock the keypad when setting
up the protocol.
If the option is available, use the
pump key to place the pump
in the unlocked position (see
picture)
OR
Enter the keypad code
(see Security Settings on page 21).
NOTE: Using the pump key to unlock the keypad
also unlocks the cassette latch (see Attach a Cassette
on page 18 for more information).
Max. Hard
limit range
(amber)
Soft limit
range
(green)
Min. hard
limit range
(amber)
®
Outside
soft limit
range
(amber)
®
-
-
®
-
29