Electrical Equipment Specification; Position Of Limit Switch; Specification Of Limit Switch; Location Of Limit Switch - YASKAWA MOTOMAN-ES165D Instructions Manual

155976-1CD
ES165D
8

Electrical Equipment Specification

8.1

8.1.1 Specification of Limit Switch

8.1.2 Location of Limit Switch

8 Electrical Equipment Specification

8.1 Position of Limit Switch

Position of Limit Switch
1. The interference limit switch at S-, L- and U-axes electrically limit the
operating range of respective axes by adjusting the position of the dog
using the limit switch.
The positions of the mechanical limits (mechanical stoppers) at S-, L-
and U-axes are changeable.
When the limit switch is activated, the power supply to the manipulator
is interrupted, then the manipulator makes an emergency stop as a
result. Refer to section 8.9 "Overrun/Tool Shock Sensor Releasing" in
"DX100 INSTRUCTIONS" for releasing the status of this overrun.
2. The range of S-, L- and U-axes limit switches are set to the maximum
operating range before shipping.
In case of re-adjusting the operating range of each subject
axis, it is also required to change the dog location and limit
NOTE
values in software. Contact your YASKAWA representative
if re-adjustment is required.
The limit switch is optional. For the S-, L-, and U-axes with limit switch
specifications, the limit switch is located on S-, L-, and U-axis respectively.
For their locations, refer to Fig. 8-1 "Location of Limit Switch".
Fig. 8-1: Location of Limit Switch
L-axis overrun
limit switch
8-1
L- and U-axes interference
limit switch
S-axis overrun
limit switch
HW0485249
49 of 92