Yealink CP860 User Manual page 149

You can also set up a conference with more than two parties when you have multiple accounts
on the phone. You can view and manage each participant in the conference call.
The way to set up a conference call using hook flash may be different for different gateways/PBX
Note
servers.
To set up a conference call:
Place a call to the first party.
1.
When the first party answers the call, press the Flash soft key to activate a hook flash.
2.
The message "Flashing" displays on the screen for about one second and the active call is
placed on hold.
Enter the number of the second party.
3.
When the second party answers the call, press the Flash soft key again to join two parties in
4.
the conference.
To remove this party from the conference call, press the Flash soft key.
To add an additional party to the conference, press the Conf soft key (another account is
5.
needed).
Enter the number of the new party and then press
6.
Press the Conf soft key when the party answers.
7.
Repeat steps 5 to 7 to join more parties in the established conference call.
8.
You can create a conference between an active call and a call on hold by pressing the the Conf
soft key.
To set up a conference call with an active call and a call on hold:
Establish two calls on the phone.
1.
Press
2.
Press the Conf soft key to join the two calls in the conference.
3.
During the conference call, you can do the following:
Press the Hold soft key to place the conference on hold.
-
Press the Conf soft key to join more parties in an established conference call.
-
Press the Manage soft key, and then press
-
Press the FarMute soft key to mute the party. The muted party can hear everyone, but

no one can hear the muted party.
or to select an active call.
Using Your Phone with PSTN Account
, , or the Send soft key.
or to select the desired party:
137