Multicast Paging - Yealink CP860 User Manual

User Guide for the CP860 HD IP Conference Phone
Intercom Barge
You can enable or disable the phone to automatically answer an incoming intercom call while
there is already an active call on the phone. If Intercom Barge is enabled, the phone will
automatically answer the intercom call and place the active call on hold. If Intercom Barge is
disabled, the phone will handle an incoming intercom call like a waiting call. Intercom Barge is
disabled by default.
To enable the phone to receive a new incoming call when it has an active call, make sure that call
Note
waiting feature is enabled on the phone in advance. For more information, refer to
on page 87.
To configure intercom features via phone user interface:
Press Menu->Features->Intercom.
1.
Make the desired changes.
2.
Press the Save soft key to accept the change or the Back soft key to cancel.
3.
These specific parameters are configurable via web user interface at the path
Features->Intercom.
Using Intercom
To place an intercom call when the target phone is idle:
Press the intercom key when the phone is idle.
1.
The called destination plays a warning tone and automatically answers the call in the
hands-free (speakerphone) mode by default.
Press
2.

Multicast Paging

You can use multicast paging to quickly and easily broadcast time sensitive announcements to
people who are listening to a specific multicast group and a specific channel. You can configure
a paging key or paging list key on the phone, which allows you to send a Real Time Transport
Protocol (RTP) stream to the pre-configured multicast address(es) and channel(s) without
involving SIP signaling. You can configure the phone to receive an RTP stream from
pre-configured multicast listening address(es) and channel(s) without involving SIP signaling.
You can specify up to 31 multicast listening addresses and channels.
106
or the EndCall soft key, to end the intercom call.
Call Waiting