Table of Contents
Advertisement
Configuration
March 2017
Passive device communication
In case the Primary and Backup system hubs are connected to different ports on the host system, the
same Modbus address can be used for communication with the two system hubs. Then there is no need
to use individual Modbus addresses for the Primary and Backup devices. When communicating with a
host system via RS232 interface, separate host ports must be used, and the Allow Passive device to reply on
common Modbus address option needs to be enabled.
Finish the installation wizard
Once the redundancy configuration is finished:
1. In the 2460 System Hub Redundancy window, click the Next button.
2. Proceed with
76
"Finish the installation" on page 67
to finish the installation wizard.
Reference Manual
00809-0100-2460, Rev DB
Configuration
Hide quick links:
Advertisement
Table of Contents
