Configuring Rules For Filtering Pim-Sm (Ipv6) Register Messages - Huawei Quidway S7700 Configuration Manual - Multicast

Quidway S7700 Smart Routing Switch
Configuration Guide - Multicast
suppression period, the DR periodically sends a Probe message (null Register message) to notify
the RP that the multicast source is still in the active state. After the register suppression expires,
the DR resends the Register message carrying a multicast data packet.
Pre-configuration Tasks
Before adjusting control parameters of source registering, complete the following tasks:
l
l
Data Preparation
To adjust control parameters of source registering, you need the following data.
No.
1
2
3
13.7.2 Configuring Rules for Filtering PIM-SM (IPv6) Register
Messages
You can configure policies on filtering Register messages on all the routers that may become
RPs. By default, the checksum is calculated based on the entire Register message. You can
configure the device to calculate the checksum based on only the header of a Register message.
Context
Do as follows on switchs that may become RPs:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
pim-ipv6
The PIM-IPv6 view is displayed.
Step 3 Run:
register-policy { advanced-acl6-number | acl6-name acl6-name }
Issue 01 (2011-07-15)
NOTE
Switchs under the control of default values can work normally. In the S7700, users can adjust related
parameters according to the specific network environment. If there is no special requirement, default values
are recommended.
Configuring a unicast routing protocol
Configuring Basic PIM-SM (IPv6) Functions
Data
ACL6 rules used by the RP to filter Register messages
Timeout period for keeping the suppressed state of the source registering
Interval for sending null Register messages to the RP
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
13 PIM-SM (IPv6) Configuration
476