Configuring The Period For Keeping The Assert State - Huawei Quidway S7700 Configuration Manual - Multicast
Smart routing switch
Hide thumbs
Also See for Quidway S7700:
- Configuration manual (833 pages) ,
- Configuration manual - ethernet (648 pages) ,
- Hardware description (205 pages)
Table of Contents
Advertisement
Quidway S7700 Smart Routing Switch
Configuration Guide - Multicast
l
Data Preparation
To adjust control parameters for asset, you need the following data.
No.
1
12.9.2 Configuring the Period for Keeping the Assert State
The device that fails in the election prevents its downstream interface from forwarding multicast
data. After the holdtime of the Assert state expires, the downstream interface can forward
multicast data.
Context
Do as follows on the PIM-DM switch:
Procedure
l
l
Issue 01 (2011-07-15)
Configuring Basic PIM-DM (IPv6) Functions
Data
The period for keeping the Assert state
NOTE
The configuration involves the following two cases:
l Global configuration: It is valid on each interface.
l Configuration on an interface: The configuration on an interface takes precedence over the global
configuration. If the configuration on an interface is not done, the global configuration is used.
Global Configuration
1.
Run:
system-view
The system view is displayed.
2.
Run:
pim-ipv6
The PIM-IPv6 view is displayed.
3.
Run:
holdtime assert interval
The period for keeping the Assert state is set.
The switch that fails in the election prohibits its downstream interface from forwarding
multicast data.
After the Holdtime timer times out, the downstream interface continues to forward
packets.
Configuration on an Interface
1.
Run:
system-view
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
12 PIM-DM (IPv6) Configuration
439
Advertisement
Table of Contents
