Adding An Interface To A Multicast Group Statically; Checking The Configuration - Huawei Quidway S7700 Configuration Manual - Multicast

Quidway S7700 Smart Routing Switch
Configuration Guide - Multicast
The interface can be an Ethernet interface, a GE interface, an XGE interface, or an Eth-Trunk
interface.
Step 3 Run:
port hybrid tagged vlan { { vlan-id1 [ to vlan-id2 ] }&<1-10> | all }
The interface is added to VLANs.
----End

2.4.5 Adding an Interface to a Multicast Group Statically

Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface interface-type interface-number
The interface view is displayed.
The interface can be an Ethernet interface, a GE interface, an XGE interface, or an Eth-Trunk
interface.
Step 3 Run:
l2-multicast static-group [ source-address source-ip-address ] group-address group-
ip-address vlan { vlan-id1 [ to vlan-id2 ] } &<1-10>
The interface is added to the multicast group statically. You can also run the l2-multicast static-
group [ source-address source-ip-address ] group-address group-ip-address1 to group-ip-
address2 vlan vlan-id command to join the interface to the group-address in batches.
After an interface is added to a multicast group statically, multicast protocol packets are not
forwarded to the router interface.
----End

2.4.6 Checking the Configuration

Prerequisite
The configuration of static Layer 2 multicast for a VLAN is complete.
Issue 01 (2011-07-15)
NOTE
If multicast VLAN replication is not configured, the interface of the S7700 that connects to a router and
receives the multicast packets from the router and the interface that connects to users and sends multicast
packets to users must be added to the same VLAN.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
2 IGMP Snooping Configuration
28