Adjusting Control Parameters Of A C-Bsr - Huawei Quidway S7700 Configuration Manual - Multicast

Quidway S7700 Smart Routing Switch
Configuration Guide - Multicast
The PIM-IPv6 view is displayed.
Step 3 Run:
c-rp priority priority
The priority of the C-RP is configured.
Step 4 Run:
c-rp advertisement-interval interval
The interval during which the C-RP sends advertisement messages is configured.
Step 5 Run:
c-rp holdtime interval
The period for keeping the advertisement message received from the C-RP is configured.
This period must be longer than the interval during the C-RP sends advertisement messages.
The C-RP periodically sends advertisement messages to the BSR. After receiving the
advertisement messages, the BSR obtains the Holdtime period from the messages. During the
Holdtime period, the advertisement message is valid. When the Holdtime period expires, the C-
RP ages.
----End

13.5.3 Adjusting Control Parameters of a C-BSR

At first, each C-BSR considers itself as a BSR and sends Bootstrap messages to all devices in
the network. You can adjust the hash mask length of the C-BSR carried in a Bootstrap message,
the C-RP priority, the interval for sending Bootstrap messages, and the holdtime of Bootstrap
messages on a device configured with the C-BSR.
Context
Do as follows on the switch on which the C-BSR is configured:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
pim-ipv6
The PIM-IPv6 view is displayed.
Step 3 Run:
c-bsr hash-length hash-length
The hash mask length of the C-BSR is configured.
Issue 01 (2011-07-15)
NOTE
Do as follows on the switch that has been configured with a C-BSR. This configuration is optional. If there
is no special requirement, default values are recommended.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
13 PIM-SM (IPv6) Configuration
466