Huawei Quidway S7700 Configuration Manual - Multicast page 360

Quidway S7700 Smart Routing Switch
Configuration Guide - Multicast
Step 3 Configure the static multicast route.
# Configure a static multicast RPF route on Switch B, and configure Switch C as the RPF
neighbor.
[SwitchB] ip rpf-route-static 8.1.1.0 255.255.255.0 13.1.1.2
Step 4 Verify the configuration.
# Run the display multicast rpf-info command on Switch B to view the RPF information of
the source. The RPF information is as follows. The RPF routes and the RPF neighbor are updated
according to the static multicast route.
[SwitchB] display multicast rpf-info 8.1.1.2
VPN-Instance: public net
RPF information about source 8.1.1.2:
----End
Configuration Files
l
Issue 01 (2011-07-15)
RPF interface: vlanif10, RPF neighbor: 9.1.1.1
Referenced route/mask: 8.1.1.0/24
Referenced route type: unicast
Route selection rule: preference-preferred
Load splitting rule: disable
RPF interface: vlanif40, RPF neighbor: 13.1.1.2
Referenced route/mask: 8.1.1.0/24
Referenced route type: mstatic
Route selection rule: preference-preferred
Load splitting rule: disable
Configuration file of Switch A
#
sysname SwitchA
#
vlan batch 10 20 30
#
multicast routing-enable
#
interface Vlanif10
ip address 9.1.1.1 255.255.255.0
pim dm
#
interface Vlanif20
ip address 8.1.1.1 255.255.255.0
pim dm
#
interface Vlanif30
ip address 12.1.1.1 255.255.255.0
pim dm
#
interface GigabitEthernet1/0/0
port hybrid pvid vlan 10
port hybrid untagged vlan 10
#
interface GigabitEthernet2/0/0
port hybrid pvid vlan 20
port hybrid untagged vlan 20
#
interface GigabitEthernet3/0/0
port hybrid pvid vlan 30
port hybrid untagged vlan 30
#
ospf 1
area 0.0.0.0
network 8.1.1.0 0.0.0.255
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
9 IPv4 Multicast Routing Management
341