Optional) Configuring The Interval For Checking The Forwarding Rate Of Multicast Data - Huawei Quidway S7700 Configuration Manual - Multicast

Quidway S7700 Smart Routing Switch
Configuration Guide - Multicast
Pre-configuration Tasks
Before configuring the SPT switchover, complete the following tasks:
l
l
Data Preparation
To configure the SPT switchover, you need the following data.
No.
1
2
3
6.11.2 (Optional) Configuring the Interval for Checking the
Forwarding Rate of Multicast Data
You can configure conditions for the SPT switchover and set the interval for checking the
forwarding rate of multicast data on the DR at the group member side.
Context
Do as follows on all the switchs that may become a DR at the member side:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
pim [ vpn-instance vpn-instance-name ]
The PIM view is displayed.
Step 3 Run:
spt-switch-threshold { traffic-rate | infinity } [ group-policy { basic-acl-number
| acl-name acl-name } [ order order-value ] ]
The SPT switchover condition is set.
l traffic-rate: specifies the rate threshold of the SPT switchover.
l infinity: indicates that the SPT switchover is not triggered forever.
Issue 01 (2011-07-15)
Configuring a unicast routing protocol
Configuring Basic PIM-SM Functions
Data
Rate threshold that a leaf PIM switch switches packets from the RPT to the SPT
Group filtering policy and sequence policy for the switchover from the RPT to the
SPT
Interval for checking the rate threshold of multicast data before the RPT-to-SPT
switchover
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 PIM-SM (IPv4) Configuration
184