Huawei Quidway S7700 Configuration Manual - Multicast page 368

Quidway S7700 Smart Routing Switch
Configuration Guide - Multicast
SwitchB
Configuration Roadmap
The configuration roadmap is as follows:
l
l
l
l
l
l
Data Preparation
To complete the configuration, you need the following data:
l
l
l
l
Issue 01 (2011-07-15)
GE2/0/1 192.168.1.1/24
VLANIF20
GE2/0/2 192.168.2.1/24
VLANIF30
GE2/0/3 192.168.3.1/24
VLANIF40
LoopBack0 1.1.1.1/32
GE1/0/0 192.168.1.2/24
VLANIF50
GE2/0/0 192.168.4.1/24
VLANIF60
Assign IP addresses to interfaces on switches.
Configure IS-IS to implement interworking among all the switches and ensure that route
costs are the same.
Enable multicast on all the switches, enable PIM-SM on all the interfaces, and set the
loopback interface on Switch A as an RP.
Configure stable-preferred multicast load splitting on Switch E to ensure the stability of
multicast services.
HostA needs to receive data from some multicast groups for a long period. Add the host-
side interfaces of Switch E to multicast groups in batches.
HostA needs to receive data from a new multicast group. According to networking
requirements, set different multicast load splitting weights for upstream interfaces on
Switch E to ensure that multicast traffic is distributed unevenly.
IP address of the multicast source
IP addresses of interfaces on the switches
Addresses of the multicast groups to which the host-side interfaces of Switch E are added
in batches
Multicast load splitting weights of upstream interfaces on Switch E
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
9 IPv4 Multicast Routing Management
GE2/0/0
VLANIF80
Switch D GE1/0/0
VLANIF90
GE2/0/0
VLANIF100
Switch E GE1/0/1
VLANIF110
GE1/0/2
VLANIF120
GE1/0/3
VLANIF130
GE2/0/0
VLANIF140
192.168.5.1/24
192.168.3.2/24
192.168.6.1/24
192.168.4.2/24
192.168.5.2/24
192.168.6.2/24
10.110.2.2/24
349