Huawei Quidway S7700 Configuration Manual - Multicast page 396

Quidway S7700 Smart Routing Switch
Configuration Guide - Multicast
Figure 10-1 Networking diagram for configuring basic MLD functions
Switch
SwitchA
SwitchB
SwitchC
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
3.
Data Preparation
To complete the configuration, you need the following data:
l
Procedure
Step 1 Create VLANs and VLAN interfaces on the S7700s and assign IP addresses to the VLAN
interfaces. The configuration procedure is not provided here.
Step 2 Enable multicast on the S7700s and enable MLD and IPv6 PIM-DM on the interfaces connected
to user hosts.
# Enable multicast on SwitchA, enable MLD and IPv6 PIM-DM on VLANIF 100, and set the
MLD version to 2.
Issue 01 (2011-07-15)
SwitchA
GE2/0/0
SwitchB
GE2/0/0
PIM network
SwitchC
GE2/0/0
Physical interface
GE1/0/0
GE2/0/0
GE1/0/0
GE2/0/0
GE1/0/0
GE2/0/0
Enable IPv6 Multicast on the S7700s.
Enable IPv6 PIM-SM on all the interfaces on S7700.
Enable MLD on the interface at the host side.
MLD version running between the S7700s and the user hosts
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
GE1/0/0
3000::12/64
GE1/0/0
3001::10/64
GE1/0/0
3001::12/64
VLANIF interface
VLANIF100
VLANIF101
VLANIF200
VLANIF201
VLANIF300
VLANIF301
10 MLD Configuration
Ethernet
HostA
Receiver
N1
HostB
Leaf network
HostC
Receiver
N2
HostD
Ethernet
IP address
3000::12/64
2002::1/64
3001::10/64
2002::1/64
3001::12/64
2002::1/64
377