Quidway S7700 Smart Routing Switch
Configuration Guide - Multicast
Step 3 Run:
mld-snooping version version
The version is configured for MLD protocol packets that can be processed by MLD snooping.
The version can be set to 1 or 2.
By default, the S7700 can process MLDv1 packets.
----End
11.3.7 Checking the Configuration
Procedure
Step 1 Run the display mld-snooping configuration command to check the configuration information
of MLD snooping.
Step 2 Run the display mld-snooping [ vlan vlan-id ] command to check the status of MLD snooping
in a VLAN.
Step 3 Run the display mld-snooping port-info [ vlan vlan-id [ group group-ipv6–address [ source-
address source-ipv6–address ] | verbose ] ] command to check information about member
interfaces of a multicast group and the router interface in a VLAN.
Step 4 Run the display mld-snooping router-port [ vlan vlan-id ] command to check information
about the router interface in a VLAN.
----End
11.4 Configuring a Multicast Group Policy for a VLAN
This section describes how to configure a multicast group policy for a VLAN.
11.4.1 Establishing the Configuration Task
Applicable Environment
You can configure policies to control the multicast groups that the hosts in a VLAN can join.
Pre-configuration Tasks
Before configuring a multicast group policy for a VLAN, complete the following task:
l
Data Preparation
To configure a multicast group policy for a VLAN, you need the following data.
Issue 01 (2011-07-15)
NOTE
The display mld-snooping port-info command displays only the information about the static member
interface or static router interface in Up state. If the static member interface or static router interface in
Down state, you can run the display mld-snooping configuration command to check the configuration
of the interface.
11.3 Enabling MLD Snooping
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
11 MLD Snooping Configuration
392