Configuring The Ipv6 Multicast Forwarding Boundary On An Interface - Huawei Quidway S7700 Configuration Manual - Multicast

Quidway S7700 Smart Routing Switch
Configuration Guide - Multicast
Applicable Environment
In the IPv6 network, the multicast information each multicast group corresponds to is transmitted
in a certain range. In the S7700, you can define the IPv6 multicast forwarding range by using
the following methods:
l
Pre-configuration Tasks
Before limiting the range of multicast forwarding, complete the following tasks:
l
l
Data Preparation
To limit the range of multicast forwarding, you need the following data.
No.
1
2
14.4.2 Configuring the IPv6 Multicast Forwarding Boundary on an
Interface
When an interface on a multicast device is configured with a forwarding boundary for a specified
group, the forwarding scope of IPv6 multicast packets is restricted.
Context
By default, the IPv6 multicast forwarding boundary is not set on an interface.
Do as follows on the multicast switch:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface vlanif interface-number
The interface view is displayed.
Step 3 Run:
multicast ipv6 boundary ipv6-group-address ipv6-group-mask-length
Issue 01 (2011-07-15)
Configuring an IPv6 multicast forwarding boundary on an interface to form a closed
multicast forwarding area. When an interface of a switch is configured with the forwarding
boundary for a group, the interface does not forward or receive any packet for the group.
Configuring a unicast routing protocol
Configuring basic multicast functions
Data
Group address, mask, and mask length of the IPv6 multicast forwarding boundary
TTL threshold for IPv6 multicast forwarding
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
14 IPv6 Multicast Routing Management
518