Enabling A Bsr Administrative Domain; Configuring The Boundary Of A Bsr Administrative Domain - Huawei Quidway S7700 Configuration Manual - Multicast

Quidway S7700 Smart Routing Switch
Configuration Guide - Multicast

6.6.2 Enabling a BSR Administrative Domain

Enable BSR administrative domains on all devices in a PIM-SM network.
Context
Do as follows on all switchs in the PIM-SM network:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
pim [ vpn-instance vpn-instance-name ]
The PIM view is displayed.
Step 3 Run:
c-bsr admin-scope
The division of BSR administrative domains is enabled in a PIM-SM network.
----End

6.6.3 Configuring the Boundary of a BSR Administrative Domain

After an interface is configured as a BSR administrative domain boundary, all the multicast
packets for the groups in this BSR administrative domain cannot pass this interface.
Context
Do as follows on all switchs at the boundary of a BSR administrative domain:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface interface-type interface-number
The interface view is displayed.
The interface can be a VLANIF interface, or an Loopback interface.
Step 3 Run:
multicast boundary group-address { mask | mask-length }
Issue 01 (2011-07-15)
NOTE
The switchs outside the BSR administrative domain cannot forward the multicast packets of the BSR
administrative domain.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 PIM-SM (IPv4) Configuration
164