Table of Contents
Advertisement
Engine
Installing the cylinder
RIGHT CYLINDER
•
Fit the piston.
•
Remove the cloth used to prevent for-
eign bodies from getting into the crank-
case.
•
Turn the rings so that the coupling ends
are 120 degrees from each other.
•
Place a new metal gasket between the
crankcase and the cylinder. Place the
two dowel pins on the stud bolts. Lu-
bricate the piston and the cylinder.
Lock connecting rod motion with the
fork tool. Using the suitable piston ring
clamp tool, place the cylinder and fit the
chain in the timing system plate.
CAUTION
DURING THIS OPERATION, PAY ATTENTION NOT TO
DAMAGE THE PISTON.
Specific tooling
020674Y Piston ring clamp
020716Y Connecting rod locking
•
Remove the piston ring clamp tool and
finish positioning the cylinder.
Specific tooling
020674Y Piston ring clamp
ENG - 154
STELVIO 4V - 1200
Advertisement
Table of Contents
