Engine Temperature Sensor; Engine Temperature Sensor Resistance - MOTO GUZZI Stelvio 1200 4V Service Manual

Hide thumbs Also See for Stelvio 1200 4V:
Table of Contents

Advertisement

Electrical system
resistance. If resistance is over 2.5 kOhm, it means the red cable is shorted to positive and
the cable harness should be restored
shorted to negative: disconnect the sensor connector and check the ground insulation of the
red cable (from throttle sensor connector or control unit connector): if there is continuity to
ground, restore the cable harness; if it is ground insulated, the resistance between PIN A
and PIN C is below 1.3 kOhm; therefore, the throttle body should be replaced
NAVIGATOR: ADJUSTMENT
Throttle position autodetection: It allows the control unit to detect the closed throttle position; just
press the Enter key.
Self-adjustable parameters reset: Lambda probe self-adaptability parameters reset: operation to be
carried out after the throttle body is cleaned or in the case a new engine, a new lambda probe or a new
injector is fitted, or the correct operation of the injection system or the valves is restored.
NAVIGATOR: RESET PROCEDURE
Once the throttle body or the injection control unit is replaced, it is necessary to connect to the diagnosis
instrument selecting FUEL INJECTION and carry out the operation: Throttle position autodetection.

Engine temperature sensor

Function
tells the engine temperature to the control unit so
as to optimise its operation.
Operation / Operating principle
NTC type sensor (resistance sensor, inversely
variable with temperature).
Level in electrical circuit diagram:Temperature
sensors
Location:
Sensor: within the engine "V"
Connector: on the sensor
Electrical specifications:
1
Resistance at -40 °C (-40 °F)
2
Resistance at -30 °C (-22 °F)
3
Resistance at -20 °C (-4 °F)
4
Resistance at -10 °C (14 °F)
5
Resistance at 0 °C (32 °F)
6
Resistance at +10 °C (50 °F)
7
Resistance at +20 °C (68 °F)
8
Resistance at +30 °C (86 °F)
9
Resistance at +40 °C (104 °F)
10
Resistance at +50 °C (122 °F)
ELE SYS - 64
E
NGINE TEMPERATURE SENSOR RESISTANCE
Specification
STELVIO 4V - 1200
Desc./Quantity
100.950 kOhm
53.100 kOhm
29.120 kOhm
16.600 kOhm
9.750 kOhm
5.970 kOhm
3.750 kOhm
2.420 kOhm
1.600 kOhm
1.080 kOhm

Advertisement

Table of Contents
loading

Table of Contents