Engine
•
Place the U-bolt on the rocking levers
making sure the two reference pins
match the seats on the cam tower.
•
Tighten the two screws operating diag-
onally and in stages.
Installing the overhead camshaft
•
Place the bowls in the cam tower, if
those previously removed are refitted
be careful not to interchange them.
•
Place the camshaft with the gear seat
on the dowel side.
•
Place the U-bolt on the camshaft mak-
ing sure the two reference pins match
the seats on the cam tower.
•
Tighten the four screws operating di-
agonally and in stages.
Timing
ENG - 142
STELVIO 4V - 1200