Engine
Installing the generator
•
If the sealing ring has been previously
removed, replace it using the punch of
the timing system cover sealing ring.
Specific tooling
05.92.72.30 Timing system cover sealing ring
punch
•
Place the bolt and the pin in the gen-
erator cover.
•
Replace the gasket and place the al-
ternator frame using the front cover in-
sertion cone.
•
Remove the insertion cone afterwards.
Specific tooling
05.91.17.30 Front cover insertion cone
•
Tighten the two screws.
ENG - 122
STELVIO 4V - 1200