MOTO GUZZI Stelvio 1200 4V Service Manual page 248

Braking system
•
Extract one pad at a time.
CAUTION
AFTER REMOVING THE PADS, DO NOT OPERATE THE
BRAKE LEVER OR THE CALLIPER PLUNGERS COULD
GO OUT OF THEIR SEATS RESULTING IN BRAKE FLUID
LEAKS.
Installing
•
Insert two new pads, placing them so
that the holes are aligned with the cal-
liper holes.
CAUTION
ALWAYS REPLACE BOTH PADS AND MAKE SURE THEY
ARE CORRECTLY POSITIONED INSIDE THE CALLIPER.
•
Position the anti-vibration plate.
•
Insert both pins.
•
Position both split pins.
•
Abut the plungers against the pads,
acting on the brake pump lever several
times.
•
Check the brake fluid level in the res-
ervoir.
BRAK SYS - 248
STELVIO 4V - 1200