Installing The Crankshaft - MOTO GUZZI Stelvio 1200 4V Service Manual

Engine
PAY ATTENTION TO CRANKSHAFT ROTATION WHEN ONLY THE CONNECTING RODS ARE
FITTED BECAUSE IT COULD HIT THE TWO LUBRICATION JETS INSIDE THE CRANKCASE.

Installing the crankshaft

•
Fit the shim washer inside the crank-
case with the chamfered side facing
the generator side.
•
Lubricate the crankshaft bushing on
the crankcase, generator side.
•
Use the sealing ring fitting tool on the flywheel-side flange to fit the sealing ring on the flange.
Specific tooling
19.92.71.00 Tool to fit the seal ring on the flywheel-side flange
•
Prepare loctite 510 between the crankcase and the crankshaft flange, on the flywheel side.
•
Fit the crankshaft on the crankcase,
flywheel side.
•
Mark the crankshaft on the flywheel
side with the crankpin facing upwards.
•
Place the suitable sealing ring centring
tool on the crankshaft.
Specific tooling
12.91.20.00 Tool to fit the flywheel-side flange
together with seal ring on the crankshaft
ENG - 166
STELVIO 4V - 1200