[Page Edge Filler (Adf)]/[Page Edge Filler (Fb)] (Fi-7700/Fi-7700S); Removing Shadows/Streaks That Appear Around The Scanned Image - Fujitsu FI-7600 Operator's Manual

Chapter 8 Operational Settings
Removing Shadows/Streaks that Appear around
the Scanned Image
[Page Edge Filler (ADF)]/[Page Edge Filler (FB)]
(fi-7700/fi-7700S)
Depending on the condition of the documents that you scan,
the shadow of the document may appear as black streaks.
In that case, you can improve the image quality around the
edges of the document by using the "Page Edge Filler"
function to fill in the edges.
1
Start up the Software Operation Panel.
For details, refer to "8.1 Starting Up the Software Operation Panel"
(page 156).
2
From the listing on the left, select [Device Setting 2] 
[Page Edge Filler (ADF)] or [Page Edge Filler (FB)] (fi-
7700/fi-7700S).
3
Specify the width of each margin to fill in: top/bottom/left/
right.
ADF
T
T: top = 0 to 15 mm
B: bottom = -7 to 7 mm
R: right = 0 to 15 mm
L R
L: left = 0 to 15 mm
Image
Area
FB [fi-7700/fi-7700S]
B
T: top = 0 to 15 mm
B: bottom= 0 to 15 mm
R: right = 0 to 15 mm
L: left = 0 to 15 mm
(in 1 mm increments)
The specified area is filled in white or black, according to the
background color.
ATTENTION
Note that if the target range of Page Edge Filler is too wide, some
characters near the edge may appear missing.
TOP
Contents
Index
Introduction
Scanner
Overview
How to Load
Documents
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Replacing the
Consumables
Troubleshooting
Operational
Settings
Appendix
Glossary
180