Fujitsu FI-7600 Operator's Manual page 174

Chapter 8 Operational Settings
Item
Pick Roller Number of sheets scanned after the pick
roller is replaced
Remaining Ink Amount of ink remaining in the print
cartridge of the imprinter
(only displayed when the imprinter is
installed)
ATTENTION
If you turned off the scanner by unplugging the power cable, or
selected [Disable power switch], the number of scanned sheets
may not be counted in [Total Count].
For details about disabling the power switch, refer to
Turning the Scanner ON/OFF [Power SW Control]" (page
■
Description
When you have replaced or cleaned a consumable part, reset the
corresponding counter by using the following procedure:
1
"Method of
204).
2
3
Resetting the Sheet Counters
If you have replaced a consumable, click the [Clear]
button of the consumable that you replaced. If you
performed cleaning, click the [Clear] button of [After
cleaning].
The counter is reset to 0.
For the ink counter, the value will be set to 100.
Click the [OK] button.
A confirmation message appears.
Click the [OK] button.
The settings are saved.
TOP
Contents
Index
Introduction
Scanner
Overview
How to Load
Documents
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Replacing the
Consumables
Troubleshooting
Operational
Settings
Appendix
Glossary
174