Chapter 3 How to Use the Operator Panel
3.3 Function Selection
This section explains about the Function Selection.
When you press the [] or [] button while the [Ready]
screen is displayed, the [Function Selection] screen is
displayed.
By using the Function Selection, you can configure the
application you want to launch when you press the [Scan/
Enter] button while the [Ready] screen is displayed.
The configured applications are applied to the application
numbers (F00 to F50/SOP) that are displayed in the indicator.
How to Use the Function Selection
[fi-7600]
[fi-7700/fi-7700S]
1 [Power] Button
2 []/[] Button
3 []/[] Button
[Scan/Enter] Button
1
Press the [Power] button on the operator panel.
The [Ready] screen is displayed on the LCD.
The indicator displays [F00] when the power has just been turned
on.
2
Press the [
] or [
] button.
The [Function Selection] screen is displayed on the LCD.
3
Press the [
] or [
] button and select a parameter, then
press the [Scan/Enter] button to confirm.
For more details about the setting parameters, refer to
Configurable in Function Selection" (page
The setup is completed when the LCD displays the [Ready] screen.
The indicator displays the configured parameter.
In this example, the indicator displays "F02" because "No.02" is
selected.
HINT
When "No.00" to "No.50" are selected, the indicator displays
"F00" to "F50".
When "SOP" is selected, "SOP" is displayed on the indicator.
SOP indicates the Software Operation Panel.
Contents
Introduction
Scanner
Overview
How to Load
Documents
How to Use the
Operator Panel
"Item
81).
Various Ways to
Scan
Daily Care
Replacing the
Consumables
Troubleshooting
Operational
Settings
Appendix
Glossary
TOP
Index
80