Disabling Paper Protection For A Single Scan After Paper Protection Is Set Off - Fujitsu FI-7600 Operator's Manual

Chapter 4 Various Ways to Scan
Disabling Paper Protection for a Single Scan
After Paper Protection Is Set Off
If you attempt to scan a wrinkled document while paper
protection is on, the scanner may detect it as a paper jam,
which causes paper protection to be set off and forces a scan
to be stopped even though paper is fed normally. In this case,
you can disable paper protection on the operator panel for a
single scan after paper protection is set off.
Operational Procedure
[fi-7600]
[fi-7700/fi-7700S]
LCD
[Menu] Button
[Scan/Enter] Button
[Menu] Button
[Scan/Enter] Button
LCD
1
After paper protection is set off, open the ADF and
remove the document.
After the document is removed, indication on the LCD of the operator
panel changes as follows:
When paper protection is set off
Paper protection (feeding noise)
Remove and check the document, and
then try again carefully.
Paper protection (feeding accuracy)
Remove and check the document, and
then try again carefully.
When the ADF is open, it might close
accidentally. Be careful not to get your
fingers caught.
2
If you open the ADF to remove the document, close it.
For details, refer to "1.4 Opening/Closing the ADF" (page
Be careful not to get your fingers caught
when closing the ADF.
ATTENTION
Confirm that the ADF is closed properly. Otherwise, the document
may not be fed into the ADF.
3
Load the documents back in the ADF paper chute
(feeder).
Contents
Introduction
Scanner
When a document is
Overview
ejected
Disable paper
How to Load
protection.
Documents
--------------------------------
Enable:Scan/Enter
(Switch:Menu)
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
24).
Replacing the
Consumables
Troubleshooting
Operational
Settings
Appendix
Glossary
TOP
Index
100