Fujitsu FI-7600 Operator's Manual page 109

Chapter 5 Daily Care
Brake Roller (× 2)
Remove the roller from the scanner.
For details about removing the brake roller, refer to
Brake Roller" (page 114).
Gently wipe off any dirt or dust along the grooves, taking care not to
damage the roller surface.
Pick Roller (× 5)
Gently wipe dirt and dust off the roller surface (and along the grooves if
it has grooves) as you rotate the roller by hand, taking care not to
damage the roller surface. Make sure that it is wiped properly because
black residue on the roller will affect the feeding performance.
Rubber Roller (× 4)
Gently wipe off any dirt or dust on the surface of the roller. Make sure
that it is wiped properly because black residue on the rollers will affect
the feeding performance.
Be careful not to damage the sponge that is attached to the roller.
Chute Roller (× 1)
With the chute roller cover open, gently wipe off any dirt or dust on the
surface of the roller. Make sure that it is wiped properly because black
residue on the roller will affect the feeding performance.
Paper Path (× 2)
Gently wipe the dirt and dust off the surface of the paper path.
Glass (× 2)
Gently wipe the dirt and dust off the surface of the glass sections.
ATTENTION
Vertical streaks may appear on the scanned image when the glass is
dirty.
Ultrasonic Sensor (× 2)/Document Sensor (× 8)
Gently wipe the dirt and dust off the surface of the ultrasonic/document
"6.2 Replacing the
sensors.
HINT
If it is difficult to clean, use a cotton swab.
Ultrasonic Sensor
Contents
Introduction
Scanner
Overview
Document Sensor
How to Load
Documents
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Replacing the
Consumables
Troubleshooting
Operational
Settings
Appendix
Glossary
TOP
Index
109