[Scan Setting For Document With Tab (Automatic Page Size Detection)] - Fujitsu FI-7600 Operator's Manual

Chapter 8 Operational Settings
Scan Setting for Documents with Tabs or Non-
Rectangular Documents
[Scan Setting for Document with Tab (Automatic
Page Size Detection)]
For a document that includes index sheets or a document with
index stickers (or tabs) attached at the bottom edge, you can
specify whether or not to include the index portion (or tab)
images during scanning using the Auto Paper Size Detection
setting.
1
Start up the Software Operation Panel.
For details, refer to "8.1 Starting Up the Software Operation Panel"
(page 156).
2
From the listing on the left, select [Device Setting 2] 
[Scan Setting for Document with Tab (Automatic Page
Size Detection)].
3
Select [Non-rectangular document], [Document with tab],
or [Document without tab].
Detection
Method
Non- Scan extra 120 mm from the detected bottom
rectangular edge of the document.
document
Document Scan extra 35 mm from the detected bottom edge
with tab of the document.
Document Terminates scanning at the time the bottom edge
without tab of the document is detected.
ATTENTION
 The scanning speed slows down if [Document with tab] or [Non-
rectangular document] is selected.
 When scanning documents with a tab or non-rectangular
documents, refer to "How to Load Documents with a Tab or
Non-Rectangular Documents" (page
 For details about setting automatic page size detection, refer to
the scanner driver's Help.
HINT
This setting can also be configured with the operator panel.
Description
51).
TOP
Contents
Index
Introduction
Scanner
Overview
How to Load
Documents
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Replacing the
Consumables
Troubleshooting
Operational
Settings
Appendix
Glossary
189