Leibinger JET2 neo Manual page 44

Page 42
Turn on the printer. For this touch the dark touch-display (1) at any position for
approx. 2 sec.
The device turns on and the message<Initialization> (2) is displayed. Wait until
the initialization is finished. After this process the message <Emergency
Shutdown> (3) is displayed.
Press the button <OK ( )> (4).
Go to the "Special functions" area by clicking on the appropriate register card
(5).
Now press the button <Fill up Routine> (6). The message <Fill up Routine>
(7) is faded-in.
Press the button <Next> (8) to start the filling routine.
Note: This process takes approx. 10 minutes.
After finishing the process an according message (9) is displayed. Press the
button <OK> (10) to finish the routine.
Press the <Close> button (11) to exit the <Special functions> area.
The message <Hydraulic control> (12) is faded-in.
Note:
For leaving the service menu the hydraulic control will be turned on again
automatically.
Press the button <OK ( ) > (13) to close the service menu.
If required the device starts automatically with the bleeding of the system.
During the process the message <Bleeding> (14) is displayed. The bleeding
takes between 1–5 min. The process can be canceled by pressing the button
<Cancel> (15).
The basic menu (16) is now displayed and the printer is ready to operate.
Release R1.07 en
Transport/Start up Group 5
JET2 neo