Leibinger JET2 neo Manual page 38

Page 36
Figure 7
Print head installation (Example)
1 – Product
2 – Conveyor belt
3 – Encoder
The print head should be attached vibration-free. The hose
connection of the print head should not be smaller as a radius of R60
statistically and dynamically not below R100!
The distance of the print head to the product depends on the required character
height. As smaller the required character height, as smaller the distance of the print
head to the product (smaller distances produce better type quality)
Note: In general a distance of round about 8-10 mm is recommended.
Release R1.07 en
Transport/Start up
6
4 – Sensor
5 – Print head
5
4
= Conveying direction
7
6 – Umbilical (Hose connection)
7 – Print head adapter
(accessories)
Group 5
1
2
3
JET2 neo