Denso BHT-500B User Manual page 100

Select "1: Ymodem" at the PROTOCOL TYPE menu to display the screen
on the right.
The highlighted settings will be the current settings.
"1: CR/LF":
Specifies line delimiters.
"2: CR/LF CODE":
Specifies handling for line delimiters in records when data files are
downloaded.
"Control code":
Does not handle line-break codes as data.
(Handles as record delimiters.)
"Data":
Handles line-break codes as data.
"3: BHT ID":
Specifies whether or not to add the BHT ID number to packets when performing YMODEM transfer.
"None" should normally be selected. To add the BHT ID number to the transfer tool, select "Add". (This
setting is not supported. Changing this setting has no result.)
"4: INTERVAL":
Specifies the retry interval within a range of 1 to 255 in units of 100 ms.
To make changes, use the cursor keys ([▲] [▼]) or numerical keys ([1] [2] [3] [4]) to highlight the item to
be set, highlight the setting value using the cursor keys ([◄] [►]), and then press the ENT key.
For "4: INTERVAL", press the ENT key to change to entry mode.
The cursor displays, allowing the previous setting to be deleted by pressing the BS/C key.
Enter a new setting values with the numerical keys and press the ENT key.
Press and hold the BS/C key to return to the SET COMMUNICATION menu.
Barcode Handy Terminal
83