Discharge Chute; Chute & Auger Cover Removal - Toro Power Max Service Manual

CHUTE AND AUGER COVER
REMOVAL
1. Disconnect the defl ector cable from the defl ector
(Fig. 206).
2. Remove the single screw retaining the gear cover,
lift the front of the cover, and slide it to the rear
(Fig. 207).
Power Max Service Manual
Fig 206
MVC-3878X
Fig 207
MVC-883X

DISCHARGE CHUTE

3. Remove the single screw between the gear and the
chute (Fig. 208).
4. Remove two screws that secure the cable clamp
bracket and the chute support bracket to the chute
(Fig. 209). Leave the cable clamped to the bracket
unless the cable is to be replaced and set aside.
Fig 208
MVC-884X
Fig 209
MVC-824X
10-1