Advertisement

CCR
Snowthrower
Model No. 38517—Serial No. 230000001 and Up
Introduction
Read this manual carefully to learn how to operate
and maintain your product properly and to avoid injury
and product damage. You are responsible for
operating the product properly and safely.
Whenever you need service, genuine Toro parts, or
additional information, contact an Authorized Service
Dealer or Toro Customer Service and have the model
and serial numbers of your product ready. The
illustration below identifies the location of the model
and serial numbers on the product. Write the numbers
in the space provided below:
Model #:
Serial #:
This manual identifies potential hazards and has
safety messages identified by the following words:
Danger signals an extreme hazard that will
cause serious injury or death if you do not follow
the recommended precautions.
Warning signals a hazard that may cause
serious injury or death if you do not follow the
recommended precautions.
Caution signals a hazard that may cause minor
or moderate injury if you do not follow the
recommended precautions.
This manual uses 2 other words to highlight
information. Important calls attention to special
mechanical information and Note: emphasizes
general information worthy of special attention.
Warning
The engine exhaust from this product contains
chemicals known to the State of California to
cause cancer, birth defects, or other reproductive
harm.
Important: This engine is not equipped with a spark
arrester muffler. It is a violation of California Public
Resource Code Section 4442 to use or operate this
Printed in USA
Original Instructions (EN)
3650 GTS
engine on any forest-covered, brush-covered, or
grass-covered land. Other states or federal areas
may have similar laws.
This spark ignition system complies with Canadian
ICES-002.
Safety
This snowthrower meets or exceeds the B71.3
specifications of the American National
Standards Institute in effect at the time of
production.
Read and understand the contents of this manual
before the engine is ever started.
alert you to potential personal injury hazards.
Obey all safety messages that follow this symbol
to avoid possible injury or death.
Improperly using or maintaining this
snowthrower could result in injury or death. To
reduce this potential, comply with the following
safety instructions.
The following instructions have been adapted from
the ANSI/OPEI standard B71.3–1995 and the ISO
8437:1989 standard.
Training
Preparation
3327-901
Form No. 3327-901 Rev A
Operator's Manual
This is the safety alert symbol. It is used to
Read the operator's manual carefully. Be
thoroughly familiar with the controls and the
proper use of the equipment. Know how to stop
the unit and disengage the controls quickly.
Never allow children to operate the snowthrower.
Never allow adults to operate the snowthrower
without proper instruction.
Keep the area of operation clear of all persons
(particularly small children) and pets.
Exercise caution to avoid slipping or falling.
Thoroughly inspect the area where you will use
the snowthrower. Remove all doormats, sleds,
boards, wires, and other foreign objects.
Release the control bar to disengage the rotor
blades before starting the engine.
2003 by The Toro Company
All Rights Reserved

Advertisement

Table of Contents
loading

Summary of Contents for Toro 38517 CCR 3650 GTS

  • Page 1 Whenever you need service, genuine Toro parts, or Safety additional information, contact an Authorized Service Dealer or Toro Customer Service and have the model This snowthrower meets or exceeds the B71.3 and serial numbers of your product ready. The specifications of the American National...
  • Page 2: Maintenance And Storage

    The following list contains safety information specific damage before operating the snowthrower. to Toro products or other safety information that you If the unit should start to vibrate abnormally, stop must know. the engine and check immediately for the cause.
  • Page 3: Safety/Instruction Decals

    Do not touch the engine while it is running or soon after it has stopped because the engine Purchase only genuine Toro replacement parts may be hot enough to cause a burn. and accessories. Safety/Instruction Decals Important: Safety and instruction decals are located near areas of potential danger.
  • Page 4 105-1978 105-3523 3327-901...
  • Page 5: Product Overview

    Product Overview Setup Installing the Handle 1. Cut the plastic tie that secures the control cable to the handle. 2. Position the upper handle as shown. m-6230 1. Discharge chute 6. Knobs 2. Chute crank 7. Handle bolt (2) 3. Control bar 8.
  • Page 6: Installing The Discharge Chute

    Mixing Gasoline and Oil m-6187 This snowthrower uses a 50:1 gasoline-to-oil mixture. Installing the Chute Crank Use Toro 50:1 2-Cycle Oil (Fuel Stabilizer Added) or an equivalent high-grade, NMMA TCW-certified 1. Insert the end of the chute crank (A) through the two-cycle oil.
  • Page 7: Filling The Fuel Tank

    3. Install the cap on the fuel container. Operation 4. Shake the container to mix the gasoline and oil thoroughly. Note: Determine the left and right sides of the machine from the normal operating position. 5. Slowly remove the cap and add the remaining amount of gasoline.
  • Page 8: Starting The Rotor Blades

    Starting the Rotor Blades Throwing Snow To start the rotor blades, hold the control bar against the handle. Warning The rotor blades can throw stones, toys and other foreign objects and cause serious personal injury to the operator or to bystanders. Keep the area to be cleared free of all objects that the rotor blades could pick up and throw.
  • Page 9: Recommended Maintenance Schedule

    Maintenance Note: Determine the left and right sides of the machine from the normal operating position. Recommended Maintenance Schedule Maintenance Service Maintenance Procedure Interval Check the control cable both initially and after the first hour of operation; adjust it if necessary. Initially Check for loose fasteners and tighten them if necessary.
  • Page 10: Inspecting The Rotor Blades

    (continuously squeals) under a heavy load, increase Note: If you use Toro 50:1 2-Cycle Oil (Fuel the belt tension by inserting the spring end into the Stabilizer Added), you do not need to add a fuel top hole of the control bar.
  • Page 11 You are responsible for presenting your equipment engine to an Authorized Service Dealer as soon as a problem exists. The warranty repairs should be If you think that your Toro Product contains a defect in materials or completed in a reasonable amount of time, not to exceed thirty (30) days.
  • Page 12 Instructions for Obtaining Warranty Service If you think that your Toro Product contains a defect in materials or workmanship, or if a normal, able-bodied adult can no longer start your product’s engine in one or two pulls, follow this procedure: 1.

This manual is also suitable for:

38517Ccr 3650 gts

Table of Contents