Toro Power Max Service Manual page 70

WHEEL CLUTCH
TRACTION DRIVE SYSTEM
9. Make sure the axle bearing end that is holding the
axle shaft is on the bottom (Fig. 157).
10. 44-tooth gears should have hub facing inward (Fig.
158).
A. Hub
9-12
Fig 157
MVC-857X.jpg
Fig 158
MVC-871XYZ.jpg
11. Slide one end of the axle shaft with tube into the
housing (Fig. 159).
12. With the woodruff key out of the other side of the
shaft as well as all the other components, install
axle bearing onto housing and then slide the shaft
in though the bearing and housing, through the two
washers and 44-tooth gear sprocket into the tube
(Fig. 160).
A
Fig 159
MVC-052X.jpg
Fig 160
MVC-056X.jpg
Power Max Service Manual