Toro Power Max Service Manual page 55

6. Remove the large hairpin on either end of the axle
(Fig. 103).
A. Hairpin Cotter
7. Slide the axle a little to the right. Move both axle
bearings inward (Fig. 104) then slide to the right until
the left end of the axle comes out of the side plate.
Withdraw the axle and remove the thrust washers,
bearings, gear and key.
A. Axle Bearing
Power Max Service Manual
TRACTION DRIVE SYSTEM
A
Fig 103
MVC-1900X.jpg
A
Fig 104
MVC-1904X.jpg
NON-WHEEL CLUTCH
8. Remove the two capscrews securing the bearing
retainers to each side of the traction frame. Slide
the bearings and retainers off the hex shaft (Fig.
105). The bearings are secured to the retainers with
Loctite and are replaced as an assembly.
A
A. Bearing Retainer
9. Remove the two screws securing the shift bracket to
the frame (Fig. 106).
Fig 105
MVC-864XYZ.jpg
Fig 106
MVC-1001X.jpg
8-3