Traction Cable Adjustment; Replace & Adjust Wheel Clutch Cables - Toro Power Max Service Manual

Traction Cable Adjustment

1. The traction lever should be in the full upright
position with some slack in the traction cable to
begin adjustment (Fig. 047).
2. Adjust using the turnbuckle; hold the cable to
prevent twisting (Fig. 048).
3. Locate the traction rod on the left side just below the
belt cover.
Adjust the cable turnbuckle until there is a slight gap
between the end of the rod and the front of the slot
(maximum 1/16" [1.5mm]). Secure the jam nut on
the turnbuckle (Fig. 049). The left hand belt cover
has been removed only for clarity.
Power Max Service Manual
Fig 048
MVC-894X
REPLACE AND ADJUST WHEEL
CLUTCH CABLES (wheel clutch
models only)
Clutch Cable Replacement
1. To replace the clutch cables, drain the fuel tank and
stand the machine on the auger. Remove both lower
covers (Fig. 050). The wheels and the bottom cover
can also be removed if desired.
CONTROLS
Fig 049
MVC-895X
Fig 050
MVC-892X
4-11