Wheel Clutch Traction Drive System (Cont.) - Toro Power Max Service Manual

WHEEL CLUTCH
TRACTION DRIVE SYSTEM
3. Install the speed control linkage through the pivot
plate and install the hair clip into the hole of the
speed control linkage on the outside of the pivot
plate (Fig. 149).
A A
A. Hairpin Cotter
4. Install long end of spring to cut out on the pivot plate
(Fig. 150) and the short end of the spring to the
frame (Fig. 151).
A. Spring
9-10
B B
Fig 149
MVC-039X.jpg
B. Speed Control Link
Fig 150
MVC-039X.jpg
5. Install friction wheel assembly. You can lay the
shift mechanism onto the housing and insert shift
shaft into friction wheel assembly in the direction
shown. It is important that the friction wheel and shift
mechanism are to the right of the snowthrower (Fig.
152).
Note: Make sure the wheel is free of dirt, oil, anti-
seize or any other lubricant.
A
Fig 151
MVC-041X.jpg
Fig 152
MVC-031XYX.jpg
Power Max Service Manual