Toro Power Max Service Manual page 60

WHEEL CLUTCH
TRACTION DRIVE SYSTEM
4. Remove 2 cap screws securing the bearing retainers
that hold the hex shaft to each side of the traction
assembly and remove both bearing retainers (Fig.
118).
Note: This will ease removal and reinstallation of the
drive chains.
5. Remove both bolts that hold the wheel clutch
assembly to the housing (Fig. 119).
9-2
Fig 118
MVC-786.jpg
Fig 119
MVC-895X.jpg
6. Remove extension spring - Unhook spring from
lower clutch collar and housing (Fig. 120).
7. Remove clutch cables - Rotate the shift collar up to
release tension on the clutch cable and maneuver Z
bend of the cable end out of the upper clutch collar
(Fig. 121).
Fig 120
MVC-897springX.jpg
Fig 121
MVC-898XB.jpg
Power Max Service Manual